J&R Special Hand Tools

J&R Engineering produces a number of specialty tools for
gunsmithing.  Standard tools with single line cutter are also available.
All tools are manufactured in the USA.

 Back to J&R Home Page
 
Multi-Line Tool
  Cut 18 to 32 lines per inch with one tool !
  Complete tool is available with 8 guides, your choice of 3 guides or 1 guide.
  Interchangeable guides allow quick changes for different LPI cuts.
  Carbide cutter gives tool 50 times longer life than standard steel cutters.
  Both push and pull configurations are available.
  Depth of cut is adjustable.
 
   90 Degree Multi-Line with Choice of One Guide ($57)
Push /Pull

   90 Degree Multi-Line with 3 Guides ($68)
Push /Pull

   90 Degree Multi-Line with 8 Guides ($90)
Push /Pull

Adjustable Scraping Tool
 
  Scraping tool cutters are made of 62 RC High Speed Steel.
  Cutters can be resharpened to a sharp, long lasting edge.
  Round cutters are used for inletting the barrel channel in the gun stock.
  The square cutter is for any hard-to-reach spot.
  The head can be adjusted for any angle for both roughing and finishing.
  Round cutters are available in 5/8", 3/4", 7/8", 1" and 1-1/4" diameters.
 
   Scraping Tool and choice of round cutter ($39)

   Additional round cutter ($7)
Size

   Square cutter ($12)


 

 
You can e-mail us at  jandrengineering@hotmail.com
This page last updated on October 17, 2007.