J&R Hand Checkering Tools

J&R Engineering produces a complete set of single line hand
tools for checkering gunstocks. These precision ground carbide
tools will outlast standard steel cast or knurled tools by 50 - 100
times. Both 90 and 75 degree tools are available in 3/32", 3/16",
3/8" and 5/8" lengths. Both push and pull tools are available.
Tools are available with handle or for the Dem-Bart, W.E.
Brownells and Gunline handle. All tools are manufactured in the USA. Special hand tools are also available.

 Back to J&R Home Page
Type 1
  5/8" cutter length
  90 or 75 degree
  Push or pull available
  Used for layout and straighting lines
 
 
   90 Degree Type 1 Hand Tool ($51)
Push /Pull

   75 Degree Type 1 Hand Tool ($55)
Push /Pull


Type 2
  3/32" or 3/16" cutter lengths
  90 or 75 degree
  Push or pull available
  Used for pointing up lines
 
 
   90 Degree Type 2 Hand Tool ($33)

Push / Pull - 3/32" / 3/16"

 
   75 Degree Type 2 Hand Tool ($36)
Push / Pull - 3/32" / 3/16"

Type 3
  3/32" or 3/16" length
  90 or 75 degree
  Push or pull available
  Used for pulling radii
 
   90 Degree Type 3 Hand Tool ($33)

Push / Pull - 3/32" / 3/16"

 
   75 Degree Type 3 Hand Tool ($36)
Push / Pull - 3/32" / 3/16"

Type 4
  3/8" length
  90 or 75 degree
  Push or pull available
  Used for straighting lines in tight spots
 
 
   90 Degree Type 4 Hand Tool ($44)

Push /Pull

   75 Degree Type 4 Hand Tool ($47)
Push /Pull


Cutters for WE Brownell's Full View, Dem-Bart and Gunline handles

  3/32",  3/16", 3/8" or 5/8" length (5/8" shown)
  90 or 75 degree
 
 
   90 Degree 5/8" ($51)


   75 Degree 5/8" ($55)

   90 Degree 3/8" ($44)

   75 Degree 3/8" ($47)

   90 Degree 3/16" ($33)

   75 Degree 3/16" ($36)

   90 Degree 3/32" ($33)

   75 Degree 3/32" ($36)

 
 
You can e-mail us at  jandrengineering@hotmail.com

This page last updated on September 1, 2007.